ISO Pumps
Garbarino
|
CN
CHEMICAL PUMPS ACCORDING TO ISO 2858 AND ISO 5199
CN Series are single stage centrifugal pumps, hydraulically balanced overhung impeller, simple volute casing, axial suction and radial discharge. Bearings are oil bath lubricated. The high standardization of the common parts simplifies spare parts storage. The bolting to the base plate through the casing feet together with spacer coupling, allow an easy disassembly of the rotating parts without disturbing the alignment and without disconnecting pipes and motor. en 1092-1 nP16 pipe flanges are used for standard construction. On request flanges can be drilled according to EN 1092-1 NP 25, ANSI 150 RF or other standard.
|
Ruhrpumpen
|
CRP ISO Process Pump
ISO 2858 and ISO 5199 End Suction Process Pump)
The CRP line of process pumps features 33 hydraulic combinations and is designed to meet the ISO 2858 and ISO 5199 specifications and comply with directive 94/9/EG (ATEX 100).
Operation limits
Maximum Pressure up to 25 bar (360 psi)
Temperature up to 300 °C (572 °F)
|
|
CRP-M Mag Drive Process Pump
Permanent Magnetic Drive Pump acc. to ISO 2858
The CRP-M pump range is equipped with a permanent magnetic drive in accordance with DIN EN ISO 2858, striking new paths especially for its design of the journal bearings, optimized internal flows and pressures, its high efficiency magnetic drive system and axial thrust balancing.
Operation limits
Maximum Pressure 16 bar (232 psi)
Temperature -120 to 450 °C (-184 to 840 °F)
|
|
CRP-M-CC Mag Drive Process Pump
Centrifugal Pump with Permanent Magnetic Drive Close Coupled
With Permanent Magnetic Drive, the CRP-M-CC sealless centrifugal pump meets full DIN EN 2858 and DIN EN ISO 15783 standards. It's 100% leakage free performance allows the safe handling of hazardous and volatile fluids.
Operation limits
Maximum Pressure to 16 bar at 120 °C (232 psi at 248 °F)
Temperature -60 °C to 250 °C (-76 °F to 482 °F)
|
|
| |
